Skip to content

Primary service

CMM Calibration and Repair


Request a quotation for verification or repair.

Request a quotation

A written quotation follows by email.

Calibration and verification are two different things

Calibration produces a measurement result with a stated uncertainty. Performance verification confirms the machine against a specification limit, most often ISO 10360-2 or ASME B89.4.1, and is usually what gets ordered under the name calibration.

Geometric adjustment and, where the controller allows it, an update to the volumetric compensation map are typically combined with verification on the same visit. OEM-locked controllers limit what can be updated in the field.

What a visit covers

The sequence below runs in the order a technician performs it, not the order a brochure lists it.

  • 01

    Scales and reader heads

    X, Y and Z scales are inspected and cleaned; reader heads checked and adjusted to proper output.

  • 02

    Air bearings and lines

    Bearing and airline condition checked; supply pressure and filtration confirmed against spec.

  • 03

    Geometry

    Straightness, linearity and squareness checked in the XY, ZX and ZY planes before length testing begins.

  • 04

    Length and probing error

    E0/E150 per ISO 10360-2, 105 measurements across five lengths and seven positions; probing error PFTU per ISO 10360-5.

Visit sequence

  • 01

    Inspect

    Scales, reader heads, air bearings and airlines checked before any test is run.

  • 02

    Test

    Geometry, then length measurement error and probing error, against the governing standard.

  • 03

    Adjust

    Compensation and geometry adjusted where the controller permits; as-found data is kept.

  • 04

    Certify

    As-left verification performed and a certificate issued with results, uncertainty and traceability.

Why Minneapolis CMM Calibration and Repair

  • 01

    As-found data kept

    Results are recorded before adjustment so an out-of-tolerance condition can be assessed, not erased.

  • 02

    Repair, not just report

    Probe heads, scales, bearings, drives and counterbalance systems are serviceable on the same visit.

  • 03

    Relocation support

    Re-verification after a machine move is scoped the same way as a scheduled interval visit.

Coverage across Minnesota and the Greater Midwest

On-site service is scheduled by route across Minneapolis and the surrounding metros listed on this site. Machines outside that radius are quoted on request.

Discuss CMM Calibration and Repair Requirements

Describe the machine and the standard the certificate needs.

A written quotation follows by email.