Supporting service
CMM Programming
Request a quotation for program development.
Request a quotation

A program that runs is not a program that measures
Programming work covers GD&T interpretation from print or model, datum structure and alignment strategy, and fixture and feature selection that holds up across a production run.
Platforms supported are named on the quotation: PC-DMIS, Calypso, MODUS, CAMIO, PolyWorks and Quindos are the ones most shops already run. Programs are written for the metrology software the shop operates today rather than requiring a change of platform to accept the work.
What's covered
Programs are built against the drawing or model, with probe and stylus configuration qualified before the first part runs. Alignment strategy, datum structure and tolerance interpretation are documented alongside the program file so a second programmer can pick up the same part without re-deriving the logic.
- 01
GD&T interpretation
Datum structure and alignment strategy built from the print or the model, not assumed from the part.
- 02
Probe and stylus selection
Configuration chosen and qualified for the feature set before programming begins.
- 03
Scanning vs. discrete point
Strategy selected by feature type and tolerance, including scan time where THP is a factor.
- 04
Reporting output
Output formatted for PPAP submission and first-article inspection reporting.
- 05
Fixture strategy
Workholding and feature access planned before the probe path is finalized.
Development sequence
- 01
Review
Print or model reviewed for datum structure and critical tolerances.
- 02
Build
Program written offline or online, with probe path and stylus qualification included.
- 03
Prove out
Program run against a known part and corrected before release.
- 04
Document
Alignment, datum scheme and reporting setup recorded for repeat production runs.

Why Minneapolis CMM Calibration and Repair
- 01
Platform-specific
Programs written in the software the shop already owns, named on the quotation.
- 02
PPAP-ready output
Reports formatted for first-article and production part approval submission.
- 03
Alignment strategy reviewed
Datum structure checked against the print, not inherited from a prior program.
Coverage across Minnesota and the Greater Midwest
On-site service is scheduled by route across Minneapolis and the surrounding metros listed on this site. Machines outside that radius are quoted on request.
Discuss CMM Programming Requirements
Send the print or model and the platform in use.
