Skip to content

Our Team

Our Team


How competence is defined, assessed, authorized and re-verified for the work described on this site.

Disciplines3
StandardISO/IEC 17025:2017
Service areas6

Disciplines Covered

Work scoped through this site covers dimensional metrology across bridge, gantry and cantilever CMMs, portable articulated arms, granite surface plates, gauge blocks, and ring and plug gauges - the equipment categories a device or precision-machining quality department typically carries on one asset list.

Competence Framework

Competence for each discipline is defined against the standard the work is performed under - ISO 10360-2, -5 and -12 for machine types, ISO 3650 for gauge blocks, and the relevant ASME B89 analogues where a customer specifies them. Articulated arms are tested to ISO 10360-12 and ASME B89.4.22 where applicable to the arm and probe configuration; laser trackers are tested to ISO 10360-10. Laboratories are selected by matching their published scope of accreditation to the instrument type, range and required uncertainty before a request is accepted.

In practice our framework runs in four steps, and it runs the same way for every discipline listed above.

How Competence Is Established

  • 01

    Defined

    Each task has a written competence requirement: the method, the equipment, the range, and the evidence that counts as proof of capability.

  • 02

    Assessed

    Capability is demonstrated against that requirement — supervised work, witnessed measurement, and comparison against a known reference.

  • 03

    Authorised

    Authorization is granted per task and per range, never as a blanket qualification, and it is recorded.

  • 04

    Re-verified

    Authorizations are reviewed on a schedule and after any change of method, equipment or standard. Training records are kept for as long as the authorization is live.

Authorization and Review

Results are reviewed before release by a role separate from the one that performed the measurement, consistent with the request-review and result-release procedures documented under ISO/IEC 17025:2017. That review confirms the method, environmental conditions, traceability statement and decision rule before a certificate is issued. Authorization to release is assigned by role within the performing laboratory, not by name.

Results are reviewed before release. The review confirms that the method used matches the method quoted, that the recorded conditions are within the limits the method requires, that the calculation and the stated uncertainty are correct, and that the certificate says what the measurement supports and nothing more. Only personnel authorized for that task and range may approve the release of a result, and the approver is recorded against the certificate.

Capacity and Continuity

Scheduling is managed across on-site routes and ship-in shipments so that a machine's downtime is known before the visit is booked. When a request exceeds a single laboratory's scope or current schedule, it is routed to a second accredited laboratory, and the customer is told which laboratory is performing the work.

We staff for cover rather than for peaks. More than one person is authorized for every routine task, so absence or a spike in demand moves the schedule and leaves the result alone.

Requirements outside current authorizations are escalated, never attempted. They are quoted through a laboratory whose scope covers the measurement, or declined with the reason stated.

Related Reading

Equipment, traceability and the management system these authorizations sit inside are described on the quality system page. Open technical roles are listed on the careers page.

Auditing a supplier?

Competence records, method statements and scope detail are supplied on request with any quotation.