Skip to content

Supporting service

Gage Calibration


Request a quotation for gage crib calibration.

Request a quotation

A written quotation follows by email.

The instruments that travel with the CMM

Calipers, micrometers, height and bore gages, indicators, gage blocks, plug, ring and thread gages, pin gages, surface plates and granite squares are handled alongside CMM service.

Accredited and non-accredited items are identified separately on the quote and on the certificate; a buyer under audit asks which items fall inside the laboratory's scope. Gage blocks are calibrated against ISO 3650, and surface plates are checked for flatness across the working grid, not just at the center.

What's included

Gage families are consolidated onto one interval and one recall list wherever the fleet allows it. A shop running a CMM alongside a hand-gage crib gains the most by syncing both schedules to the same visit or shipment window.

  • 01

    Length standards

    Gage blocks conforming to ISO 3650, step gauges, ring and plug gages, pin gage sets.

  • 02

    Hand tools

    Calipers, micrometers, height gages, bore gages and dial and digital indicators.

  • 03

    Surface references

    Granite surface plates and granite squares checked for flatness and squareness.

  • 04

    Recall management

    Due dates tracked by asset identifier so nothing ages past its interval unnoticed.

  • 05

    Thread and form gages

    Thread gages and ring gauges checked against calibrated setting standards.

Recall sequence

  • 01

    Inventory

    Gage crib catalogued with consistent asset identifiers and current due dates.

  • 02

    Schedule

    Items grouped by interval so a single visit or shipment covers as much of the crib as possible.

  • 03

    Certify

    Certificates issued per item, with accredited and non-accredited status stated.

  • 04

    Flag

    Out-of-tolerance items are reported with as-found data before any replacement is suggested.

Why Minneapolis CMM Calibration and Repair

  • 01

    One recall list

    CMM and hand-gage intervals tracked together instead of on separate schedules.

  • 02

    Scope stated per item

    Accredited and non-accredited items are marked separately on the quote.

  • 03

    Asset identifiers kept consistent

    Recall notices reference the same identifier the crib already uses.

Coverage across Minnesota and the Greater Midwest

On-site service is scheduled by route across Minneapolis and the surrounding metros listed on this site. Machines outside that radius are quoted on request.

Discuss Gage Calibration Requirements

Send the gage list and current due dates.

A written quotation follows by email.